in6

The following instructions can be used to install small to medium sized vinyl lettering
For more detailed instructions use the link at the bottom of this page

Clean the surface where you will be applying your lettering. We use a 70% denatured alcohol.
Peel the application tape of off the paper backing. Peel slowly to make sure the lettering comes off
with the tape.
Apply the lettering by running squeegee (or credit card) across the tape from one side to the other.
Make sure to apply pressure over all of the lettering to insure proper adhesion.
Remove the tape slowly making sure all of the lettering stays down. If the lettering comes up with the
tape simply lay the tape back down and re-squeegee.

The ideal temperature range for installing your graphics is 40-90 degrees F
If the temperature is below 40 degrees F simply heat the surface the lettering is being applied to with a blow drier and work in the sun
If the surface temperature is above 90 degrees F simply cool the surface with cold water and work in the shade

For more DETAILED INSTRUCTIONS including our alignment trick
Click Here or on the picture above
Click pictures to enlarge. Call 847-334-7466 for additional help